Toda parts for 4AG 16v

[ae71]

Shakotan Garage is proud to bring to you Toda racing products.




CAMSHAFT 4AGE 16v



*The below camshafts are able to be used with a OEM type of valve spring/shim setup




*8.5mm is the aprox limit before the inner shim kit is needed the below table are camshafts with lift of over 8.5mm



Intake cam upto 9.9mm lift
￥27093
Intake cam 10mm and over lift
￥36988
Exhaust cam upto 9.9mm lift
￥32285
Exhaust cam 10mm and over lift
￥42180
Intake + exhaust cam upto 9.9mm lift
￥54885
Intake + exhaust cam 10mm and over lift
￥74850


VALVE SPRING SET 16v



Replaces the standard valve springs with stiffer springs for reduced valve float at high RPM. Toda springs feature a unique "egg shaped" coil to make it safer when running high lift cams, they feature 20% more lift and 15% less weight then normal uprated valve springs.

4AGE 16v
￥12650



CAM GEAR 16v



These adjustable cam gears feature laser etched timing marks. Adjusting the cam timing can change the RPM of the power band givin you more down low or more up top depending on tuning and engine spec.

intake + exhaust adjustable camgear (also available in single gears).
￥25938


INNER SHIM KIT 16v



This kit is needed for running high lift camshafts for those serious folk. Kit includes valve springs. This also removes weight from the valvetrain reducing friction allowing the engine to rev higher and more freely.

4AGE 16v
￥82620


HIGH POWER TIMING BELT



TODA high power timing belt (vs. standard belt)

Resistance to cutting : approx. 350% ~ 400%
Heat resistance : approx. 250% ~ 300%
Tooth integrity : approx. 300% ~ 400%
Resistance to abrasion : approx. 250% ~ 300%

Standard type timing belts stretch leading to inaccurate cam timing, Toda belts have a much higher resistance to stretch

4AGE 16V
￥14960

Hi comp piston kit



4AGE 16V

includes Hi comp pistons, rings, wrist pins



18mm/20mm little end versions available for regular bigport and smallport.

￥79430



All prices are in Japanese yen and do not include shipping




THE REMAINDER OF 4AG TODA PARTS WILL BE LISTED SOON, until then if you want a price on a specific part just shoot me a PM

[R&D Mechanical]

Can you please put aus prices up too?

just make it easy for us and nick wont have a bitch again

[ae71]

as Lawson said...

this is the cheapest way for you guys. i keep my mark up % low. if i was to put my prices in AUD they would have to be 15% higher and even then i may need to change them at times.

a small inconvenience for you to have to use a currency converter but if you like to save pennies then you shoudnt mind

[R&D Mechanical]

ah good point i can understand

[shinobi]

Can you get the inner shim kit without the Valve springs? I already have them..

[ae71]

are you 100% sure that they are the same springs?

they are normally sold as a kit (obviously) ill have to call to find out

[shinobi]

Im sure they are the same, they're TODA?

[ae71]

you could always buy the kit and sell the new springs providing they are the same.

if they do it wont be all that much cheaper anyway.

[joof]

how much would shipping cost for a set of cams and the inner shim kit?

[ae71]

should be around 5.5kg...

5.5kg by EMS = 8900yen