Actually with my digital dash i kinda do!
I already do all of this when i'm driving anywhere. The engine builder said do not go over 4k and i'd rather listen to him considering i dont want to blow a lot of money for nothing. Its got nothing to do with not knowing where 4k is at all its the fact that if i accidentally miss shift or something and it rev its tits off. I was only going to get one because I can use it until i can afford the ecu and then sell it on because there's always people that wont them and i wont loose any money
its basically just a precaution to make sure i dont fuck anything up haha
Actually with my digital dash i kinda do!
Dont worry about it so much. If you go over 4k a few times you wont damage your engine.
email jessy streeter i got one a while back from japan for about $120
the dyno pull to 300rwkw
BT20v is making 300rwkw like i said i would without nitrous so now its time for some spray and see if she will run a 10s or less
do it on the cheap side ... like it was mentioned above ... get a block of wood under ya pedal ... just get a mate to measure the distance to the floor when its at 4k then cut the wood to size and drill a few holes threw it close to the pedal and throw some cable ties threw it ... when your done running it in cut the cable ties off and your all good ... and no money down.
My AE86 the long build : http://www.ae86drivingclub.com.au/fo...ead.php?t=8965 < the new rebirth of Wolverine starting from page 41.
Need Tyres? PM me, most brands in stock!
Need a Mechanic? Injector cleaning, brake and flywheel machining, custom made brake lines soft and hard, block and head decking, custom made exhausts, wheel alignments, suspension work. PM me Located 40min south of Newcastle.
and what happens when he gets to a hill and wants to keep it in a labour the motor?
let him work it out...
My AE86 the long build : http://www.ae86drivingclub.com.au/fo...ead.php?t=8965 < the new rebirth of Wolverine starting from page 41.
Need Tyres? PM me, most brands in stock!
Need a Mechanic? Injector cleaning, brake and flywheel machining, custom made brake lines soft and hard, block and head decking, custom made exhausts, wheel alignments, suspension work. PM me Located 40min south of Newcastle.
i dont think its good or nessesary to drive so crazy that you would miss shift....
if miss shifting is such a problem for you then perhaps you should convert to automatic.
Last edited by ae71; 10th February 2010 at 01:55 AM.
Posting Permissions
