Built 16v 4AGE motor and gearbox package

[Andy San]

Just an EOI at this stage, motor will properly be for sale after july 25th.

Motor:
4age 16v bigport
Balanced bottom end
Decked block
Shaved Head
Ports/combustion chambers tidied up
Heavy duty valve springs
264 cams, 8.4mm lift (from memory)
Vernier pullies
Baffled sump
T3 Quad throttle adaptor
silvertop throttle bodies
Custom made Trumpets
2ZZ Coil on plug ignition
GZE CAS
FGK Exhaust manifold and full under diff exhaust
440cc injectors
bigport fuel rail
all new water pumps, oil pumps, rings/bearings etc when it was built.
engine mounts

Drivetrain
Toda flywheel
Xtreme Paddle Clutch/ Heavy duty pressure plate
Rebuilt JDM T-50 with lockwired selector fork roll pins (eastern creek proof :lol: )
C's Short Shifter
Reduction Starter motor

Motor has done approx 1500kms since being built, Gearbox maybe 2000kms.

Makes 105kw at the wheels running on E85.

Has been a very reliable package, only had some issues with oil pumping out the cam covers at eastern creek, all it needs is a dual breather hose setup on the cam covers and it would be fine.

Looking For $3500 for the whole lot, not willing to seperate unless people want to sort out parts amongst themselves.

This motor has cost me approx $5000 to build, nothing wrong with it, im just going to a beams for more power. Ready to bolt into an 86/KE etc just needs and ECU and away you go.


Can organise freight for interstate buyers

[pen15]

what pistons does it have and do you have a dyno printout?

[Andy San]

Standard pistons,

have a sheet somewhere

[Andy San]

bumpoooo

[takai]

So nice and clean.

For reference could i get a close up of the end of the clutch master and the 4th trumpet? Curious to see if the clearance has changed between the first and second revision of the T3 manifold.

For everyone else, this setup is well worth it. Pretty well bulletproof in the bottom end, and would breath nicely at the top.

[benzo]

Fairly tempting Andy

Out of interest what ECU did you run, and why is it not included?

[Andy San]

Haltech e8, which I will be using on the beams

[Andy San]

back to the top

[billett86]

still for sale?

[Andy San]

yes still here