Guys I'm clearing out my wheel surplus, All Japanese made in good sizing/offsets. I really need to clean up space in my garage so they're priced accordingly. They are as follows:

A set of FOUR Enkei Apache IV Meshies- 5X114.3 PCD - Fronts 14x7 + 5 offset, Rears 14x8 -7.5

Description: Very rare wheels in excellent sizing, will clean up nicely- Paint on the centers is poor + pitting on the barrels (They were very filthy in the photos + indoor flash photography doesn't do them justice). NO CRACKS, however they do have a bit of guttering & two have very slight buckling as per photographs.

Center spigot hole has been bored out a little- doesn't detract from their look at all though (previous owner had them on an XC Falcon and had them modified to fit).







PRICE $380 for the set! - Very cheap! Will need redrilling/hub adaptors to suit a Sprinter etc. Hence the price.


A pair of TWO Weds sport Tri-spoke single piece wheels- 4x114.3 PCD, 14x8 -15 offset

Description: These are very light single piece wheels in good condition for their age. Have very slight pitting- most of what showed up in the photos was actually dirt & grime (again- indoor flash photography), they will clean up nicely with minimal effort. NO CRACKS. Very slight guttering and light cosmetic denting around a couple of the stud holes as per photographs.




PRICE: $420 for the pair (You'd be hard pressed to find similar Japanese made wheels cheaper).


LOCATION / POSTAGE: I'm located near Ballina & Byron bay NSW (A bit less than an hour from the Gold Coast). I'd prefer pick up in person, however I will consider couriering them via busfrieght at the buyers expense if someone is really keen on them.

CONTACT: PM me here and we can take it from there. Can provide contact phone number- just ask.

Cheers
Matt