ive got a tailshaft, pm me, se suburbs aswell
So the gearbox and tailshaft seem to be sorted out now.
I need a backing plate for a RWD 4ac or 4age to suit a T50. Anybody have one?
thanks
Rob
As title states, I want a T50 with 4a bellhousing.
(Therefore it must come from AE86 or AE71.)
I don't want a T engine T50 that has a different output shaft spline.
Price will depend on condition.
I'm also after the tailshaft to go with it.
At least the front half of the shaft.
I'm in Melbourne South eastern suburbs but will travel within metro Melbourne to pick it up. If shipping can be done at a reasonable cost this is also fine but pickup is preferable.
Thanks
Rob
Last edited by RobertoX; 23rd February 2009 at 12:59 PM.
ive got a tailshaft, pm me, se suburbs aswell
PROTEK TYRE AND AUTO
SQ ENGINEERING
NCCE
DRFTR86 & FATKE.....DOSEING COROLLAS SINCE 2009
need to say what diff your using buddy.
^^ I haven't decided yet, either a t series or the standard BW...
That is only applicable to the rear half of the tailshaft though.
DRFTR86 I'll pm you
i have a good JDM t-50 in eastern suburbs.
i don't need to get rid of it, but it's your's for the right price.
i may also have a front tailshaft half, but i'd have to check...
Last edited by *E7*; 21st February 2009 at 01:13 PM. Reason: add tailshaft
actually roberto its not. ae71 shaft for BW diff doesnt bolt together! for t-series diff you need front half sprinter and rear half t-18. so prob best to decide before hand![]()
i have a gearbox with jdm bellhousiing, it's got the t-series tailshaft and i'm in s.e suburbs, let me know mate
Ah ok, I was under the impression that they did... well since you know better, please enlighten me![]()
Which combination will work for the BW diff and the T50?
I now have an ae86 tailshaft, both bits.
My plan is to use the original ke70 diff and then switch to a t-series when I find one, maybe this wont be that easy though...
DrifTE72 I'll PM you
you could use the t-18 bellhousing with the ke70 standard tailshaft to the BW diff.
i am currently running that setup behind a 3tg/t-50 combo
-dave
t-18 bellhousing? behind a 4a?
Maybe a t-18 T50 with the KE tailshaft to BW diff? Using a 4a bellhousing