Ke70 fender mirrors. How???

[stix]

So i got the fenders and its all good but i dont know the proper whay to put them on.
What screws do I use to make it tight on the underside?
Do i just drill through the top of the pannel or should I take the pannel off compleatly.
To be honest, Ive got no idea
help us out

[AJPS]

make sure you use genuine mirrors

[toyotacrazy]

Stainless Steel nuts/bolt/washers as per factory

[stix]

How do I put them on? just drill through the side guard or take off the guard then do all that shit

I would just measure it all up and drill strait though the top and bolt them on but i dunno if im drilling into anything important

[toyotacrazy]

Wiring loom runs inside the engine bay so there's no prob there.

Best bet is to join and ask this Q and see where the guys can point you.

I would tape BOTH mirrors in place 1st just to make sure you can actually see what's behind you !

Rather pointless if you put them on & you can't see jack...


Should just be a case of positioning , drilling & bolting - Not screwing them down btw !

[stix]

yeah sweet man, cheers for that.
Ill ask on Rollaclub and see what happens.
Might just do a dodgy and see what happens

post a build thread soon

[stix]

So i put them on.
for anyone who does look at this its hella easy.
Basically just measured them up to sit just a bit higher than the indicator lights.
nothing underneath the fender so get drillin'
to tighten the nuts underneath you have to unbolt the mudguard which is quickly done with a philips head and a socket set for tighter places seeing my screwdriver is a CHODE!
there is like 10 bolts and 2 plug hole things which i forgot what they are called.......
only problem i had was getting around the air intake on the left side of the ke.
basically just ended up ripping mine out but on the first time, i didnt tighten the left mirror fully and after a while it like half fell off. nub........
looks like scuba goggles, lots of fun