not sure on how to get a smaller gap but im guessing the gap would be smaller normally, but my bumper bar brackets (the thing that holds ur bumper on in position) are bent and sh!t so i sort of had to force it on
to take ur bumper off theres 2 ways and one is a hell of a lot easier...
un bolt the bolt lacated at:
side of bumper at top -both sides
side of bumper bottom -both side
big ass bolt under ur (front) indicators
then theres a tricky nut and bolt to get to which if u look at you bumper the only thing holding it on is it the bolt runs down thru the piece holding the bumper on just use a socket and wrench to get it off, so it stops u from sitting ther for ages undoun the bolt but in fact its just twirlyn the nut & bolt
once this is undone
MAKE SURE U UNDO / UNCLIP UR FORNT INDICATORS!!
b4 u rip it off or u will have a fun time re soldering tabs to the wires!!
done!
the bumper bracket will now be attached to ur bumper it shoul be fairly straight forward to c that all u have to do is unscrew these to take off the bracket to get to your indicators
but if ur only wanting to get ur indicators off the refreshn them then just unscrew from the front with out having to take ur whole bumper off, but if ur painting the bumper u will have to remove the indicators to get a better paint finish
