4azc?? maybe..

[ae71]

i had an idea of turboing the 4ac (when i get it in) but that was going to be far too costly

i have had another idea. stuff turbo, its too expensive, what about supercharger (it maybe cheaper). i could just grab one off of a 4agze, make up some custom mounting brackets, lower the compression, run some piping, under drive it to prevent 4ac killage as soon as i turn the key. supersharger scream!!

costs
s/charger $150-200
intercooler $50
piping $50
massive thick h/g $30??
pulley thing $20
= $250-300

turbo was going to cost aprox $800!!
offcourse there is the bigport 4age option again $850 minimum

i think this will be a much more viable option than the last. i know that a 4age would be best and i would rather i 4age(i think) the any old crappy 4ac. the thing is i would be willing to push the 4ac harder i would a 4age. i would tend to baby a 4age but a 4ac it would be all on...

oh and some more questions

1) would a gze s/c be the best option? they seem cheap
2) how do you control the boost? im asuming with the pully sizes
3) do the boost vary like a turbo or dose it stay the same although the rpm?
4) do s/c have a thing in em to reduce to boost when you get off the throttel? (compressor bypass i think) how would i get on if it is surpost to run 12psi and you want to run 8psi? would you be able to ajust? it dont surpose it works like a turbo wastegate?

any comments/sergestion/answres to my questions would be aprecated

thanks

[Jason]

well if you can get the sc braket then you only have to fab the top bit

IC from a 1j/2j and use some copper pipes

[VIC_AE86]

Thread opened..

Unsure why it was locked..??

[Gilly]

do it!!!! Dave Lawson (AJPS) turboed his with success, think outside the square!! (says the pussy getting a small port!!)

[DRFT - 86]

Its been done........... some 1 posted a pic on here or toymods before with a 4ac paired up with a SC12.....
I personally wouldnt waste my time but if ur keen do it dude... would be good for a laugh.. and some backyard stylez tire smokage

[mattysshop]

dooooooo it... for a bit more strength... maybe consider a bigport bottom end? extreamly cheap to come buy... rings and bearings you can get for anout $150-$180 and put the 4AC pistons on the 4AG rods.. i haven't tried this.. or pulled one down to have a look if it would work.. so try it..

[MAT713]

mattyshop, more strength?!


what is tuffer then a 4A-C, i mean really! bahaha!


i wish i didnt sell of my SC12 when i moved up to a SC14 otherwise i would have gone the same route

[mattysshop]

i want the full version of your avitar....



jokes..

[jjoeworks]

I had something constructive to say about this topic but I forgot what I was going to say after seeing matt713 avitar. I'm with Matty - i want to see the full version.

[DRFT - 86]

We know you didnt have any constructive thoughts man.. just a constructive fantasy. no need to lie..