Sup chaps.
So any ways, my income is that of any engine builder / reconditioner. Prolblem is, we don't tend to deal with many toyota motors (funny that) I was just wondering, as I haven't had the parts / time to measure this, what is the compression ratio acheived by placing a 20V head on a 7A bottom end? What ECu are people with 7age / 7agte using?
The good thing with this is, is I get ocst price parts and free labour. Pretty sick, eh?? I was just wondering who could point me in the right direction to get some thing like this running.
Oh, oh oh!! Before I forget what flywheel / clutch combo are youse using? This bit has me stumped, remeber, I only know about engines.
Heres what I'm aiming for:
7A block bored 040 to give total capacity f 19**cc, 20 V Head (what cams would you recomend... as like says most of what we build are Mitsi's, Holdens and Fords) Froged pistonsand compression of around 9:5:1 / 10:1, H beam rods, full arp stud kit (Head studs, main cap bolts, fly wheel bolts, conrod bolts which will prolly come with the rods) port polish head, valves, valve springs... I hope to go second hand with things like manifolds etc...
Sorry to write such a huge spiel, but any info youse dudes could give me will be greatly appreciated.. and if it's good advice, I'll buy ya beer.
Thanks in advance, love
Damien.
Here's a pic of me to help you think [attachment=8917:attachment]
Budge it is 4/5K (not including turbo / tuning)
Thanks guys.
