a hammer and a chisel or flat tip screw driver, then once you are left with the little tiny bits get some bug and tar remover let it soak then put some more on, and let it soak then wipe off.
hey all jus want to know the bast way to take out my sound deadner..cheers, brendan
MY JZX83 (clicky)
My Beams Powered AE86 SOLD(clicky)
Originally Posted by destroyer
Too bad im in the same town as dr1ft-p1gim pretty sure his mx83 is the coolest.
a hammer and a chisel or flat tip screw driver, then once you are left with the little tiny bits get some bug and tar remover let it soak then put some more on, and let it soak then wipe off.
wheelfriends.wordpress.com
apparently dry ice works a treat!
1 1/2" paint scrapper and hammer, then turps
Its also easy to put the corner of a chisel through the steel so i wouldn't recommend it
ADM 4AGZE SPRINTER
JDM SR20DET TRUENO COUPE
ae86s love since 2004
Use a heat torch or a porta gas bottle to heat it and it lifts alot easier.
thats and expensive exercise, stand by dry ice is the best, just lay it out over it, with a few minutes, then move it on, deadener should flake away.
My results with portagas bottle.
[attachment=9890:attachment]
[attachment=9887:attachment]
[attachment=9888:attachment]
[attachment=9889:attachment]
paint scraper, big hammer and thinners..... thats what my girlfriend used, haha. get back to work! haha
Rubber mallet and a 12" screwdriver
I would recomend it over a normal hammer and a chisel, but still a butload of work
hair dryer, crow bar. all done in about 4 hours.
turps and rags for the little left over bits
Posting Permissions
