1. sprinter but they might be the same
2. yup
3. yup
cut the sway bar mounts off the s series and get someone with a welder and a hoist (eg local exhaust shop) to put them onto the t-18 diff, use the sway bar to locate them.
Hey everyone. I have a T18 Diff that i want to put into my ADM sprinter. my questions are
1. Do i use the Sprinter 4 links, or the T18 4 links?
2. When using the Zenki small axle lsd, Do i use the same T18 Axles and wheel bearings?
3. With the tailshaft, do i use the T18 rear and the Sprinter front section?
Also any info on adding sway bar mounts would be much appreciated.
Thanks :2thumbs:
1. sprinter but they might be the same
2. yup
3. yup
cut the sway bar mounts off the s series and get someone with a welder and a hoist (eg local exhaust shop) to put them onto the t-18 diff, use the sway bar to locate them.
Or buy AJPS weld on swaybar mounts.
Links to the diff are the same.
You can have any brew you want... as long as it's a Datsun / Corolla / What is that?
and then to take it one step further....
if you want to run a Kouki LSD in a T18 housing you can use the MX13 axles
<div class='quotetop'>QUOTE (Meathead #1 @ May 11 2008, 09:25 PM) </div>Care to explain how this works? Here's a comparison pic of an MX13 axle vs a T-series axle.
Something tells me it wont fit.
4agte finally finished. 252rwkw with more to come
you have misread....
MX13 axles into KOUKI center....
No i haven't. Zenki T-series axles are 23mm. Kouki T-series are 24.5mm. MX13 axles are 27-28mm. Have you tried it out and it all fits together?
Eddie.
4agte finally finished. 252rwkw with more to come
Posting Permissions
