Car - ae86

motor - 4age 16v

use - driving

problem - wont start


I posted a thread a while ago about swapping from a 20v to 16v. Now I have done the swap, but cant get the new engine started.
The microtech was running the 20v fine, and the 16v was running fine before being swapped over.
I have checked the dizzy wiring to the microtech. This is the only part of the wiring which I have had to change, everything else has been kept as it was.

The engine will crank, but doesnt even seem to try to start. How do I make sure the dizzy timing is set correctly?
I will need to double check it is getting spark tomorrow.

It is definately getting fuel, I could tell by the spark plugs being wet. I have set the fuel pressure to roughly 48psi(3kg/cm^2).

Any idea on where to start?