kouki coupe

[bencosgrove]

only a 3 way switch think ill need way to many parts dashloom, headlight loom as ill need one with power to flip headlight motors. ill probably just keep it levin for time being focus on diff suspension then wheels etc pm sent 44gte

[slydar]

bit of background/history.

i actually did the swap. all the trueno specific parts were swapped out.

levin coupes are awesome. it just needs paint and a front bar. much easier to work with whats there than swap back.

i swapped the trueno front onto my last car. the last owner was happy to because he preferred levins. also the adm loom suited the engine that was in the car at the time a bit better (being carby).

[bencosgrove]

i gave the front end a cut and polish last night came up way better than expected. diff should be bought next week pending money coming in. kind of wish i kept the carby motor but think it would have been to much trouble with cops etc

[plohl]

Was this at the jdmst meet on monday night?

[bencosgrove]

yeh i was there

[bencosgrove]

went to pull off water pump today as it stuffed and leaking cause the bearing is close to seized. went to pry off pump then bang snapped rear water housing haha. if anyone can weld ally on here i am happy to throw you some cash or a carton of piss to weld this back up, also where abouts would be a good place to order a new pump most places will only do ae82 pumps so far. heres the damage also no diff yet unfortuantly but the factory one is still fun in the rain!!

Uploaded with


Uploaded with


Uploaded with

[timbo]

Hit up DannyT on here, he is a master welder and works for beer! Plus he's just a top bloke. As for a pump, I'm pretty sure ADM Sprinter pumps are the same, at least the front is.

[bencosgrove]

got an ac setup, car runs good again, tested these thanks to andostack

Uploaded with


Uploaded with


Uploaded with

[baumyone]

Nice wheels, needs more low to set them off!

[Andostack]

Nice mk2s,