VOLK racing RAYS eng centre or complete rim!! must be 14 vic

[shaunpierre]

i NEED a center for my mesh rims MUST BE " volk racing rays eng" stamped. factory black but i can re paint them
also with 20 cap screw holes like in the pics

i would also purchase a full rim if i have to..
my centre is bent and when i drive wobbles like a cartoon i dont know how it happend FML these rims were a mess i got ripped but too late to complain now

or if any one knows a good repair place please let me know
see pics thanks guys

[*E7*]

i have just bought a pair of these myself, so if you'd like to compare centres to see if these would work, let me know.

seems hard to believe the center would be bent being cast. more likely the outers are bent, or it doesn't sit on your hub correctly.

put the rear up on stands and put the centre only on the hub, see if it runs true.

let me know if you want a hand.

-Dave

[shaunpierre]

thats good idea, ran out of light to day so might do that tmoz.. im 90% sure its the centre i measured the barrel and lip and they seem straight.. even butted them up against each other.. theres also no damage on them


so i got the centre and placed it on my floor, (marble) and measured the distance from the floor to the mounting surface where the cap screws are... and theres a diffrence of about 3 mm from one end to another.. i took a pic but u can hardly see

[shaunpierre]

cant really tell but the right side is higher

[shaunpierre]

cmon guys !! no one has one for sale!! rollin on stock rims us lame

[Jdm-Mcc]

If your centres are bent, then wouldnt the outers be aswell?

[*E7*]

you should be able to have the centre machined to fix it sitting on your hub properly.

pm me an offer on a pair of mine, and i'll let you know.

maybe you have a bent axle?

anyway, i'm happy to give you a hand sometime.

-dave

[shaunpierre]

pm sent

i havnt sussed it all out yet, been bisy as so much to do
but 100% centre is bent, barrrel and lip seem to be straght... when i separated there was no bias to the seal i but on, eg more sealant on one area than another indiacting high low spots and they but up against each other nice... will update on thurs

[shaunpierre]

ok bad, went to steves wheels, and they offered to take it and let me know... but were sus as also big chance of cracking after heated and pressed not to mention rip me off. then went to ferous forgings on ballarat road.. which are the only place i think that gave be best advise.. and that was to put it in the bin... chance off a hair line fracture is high not to mention it probs allready has one... to eliminate that and re heat it ect ect would cost more that purchasing new whole rim... im curently studing mech engineering and pass material science and he wasnt talking shit

so yea sadness

[shaunpierre]

prob solved thanks dave