Hang on....Nah, I have think I have 5 and 1 mixed up.
Can some one explain what this would do if powered up wired incorrectly?+
The more I think about it the more I think I am going go have to strip back the entire loom i just put through...
EDIT: Read 2nd post
Long story short, think I may have mixed them up.
I has since obtained this diagram for my MAF
I really don want to have to strip loom back to trace....
And if you ever struggling with soldiering corroded wires read this
Works a treat, mrs had all this stuff laying around in pantry.
Last edited by Futo_gt86; 29th April 2013 at 09:42 PM.
Hang on....Nah, I have think I have 5 and 1 mixed up.
Can some one explain what this would do if powered up wired incorrectly?+
The more I think about it the more I think I am going go have to strip back the entire loom i just put through...
Last edited by Futo_gt86; 29th April 2013 at 09:41 PM.
You shouldn't have to strip back the loom, just unplug everything relevant and use a multimeter to check which pins in which plugs are connected. Shouldn't take long at all. And if you have a problem then you can hopefully pull the pins out of one plug and swap them round to fix it up.