w58 to 4agte clutch

[Fashionbmx]

Ok so the measurment I took from the extreme clutch I smashed was 215 mm in diameter an as above its a w58 box.
my question is what clutchs can I get in 215mm to suit a 58 input?

[maxhag]

You can get any clutch made up to your desired specs.....

Call "Direct clutch services" in Qld, and they will make you whatever combo you like....
It's not expensive either.....


So, what you want is a 212mm 4a** clutch, but get them to use a W series spline in the middle...

[Casey-G]

What flywheel are you using? The 4agze type.. There is also 2 types of gze flywheel sizes I believe there's 210 and a 215mm and if it is that, any clutch/pressure plate made to suit an Ae(fwd) Levin e5x series gearbox will work, excedy do a really good 3 puck cushioned ceramatallic clutch kit that is good for a high output engine configuration.. Then there's also twin and triple plate clutches too but they usually require you to get a new flywheel as well

Sent from my GT-I9300 using Motorculture mobile app

[Casey-G]

Also what maxhag said, another mob to bounce a quote off would be Sunbury clutches

Sent from my GT-I9300 using Motorculture mobile app

[maxhag]

Just to add to Casey, There is no 210mm flywheel....... There is only 3 sizes in standard form. 200mm, 212mm/215mm, and the 225mm......
The 212mm and the 215mm are the same thing....




Steer clear of cushioned clutches if used for drift.... They are shit.....

[Sprinter86]

dont forget no 4! the 230mm ae101 GZE flywheel! big too big for rwd bells unfortunatly

[Casey-G]

I stand corrected aha.. Wasn't too sure if it was 212 or 210*.

The 230mm does fit in a nitepartz wseries bellhousing and its the one you want, you will notice if it is because the are a recessed type flywheel, not just the stepped flat type

Sent from my GT-I9300 using Motorculture mobile app

[Fashionbmx]

So what your saying casey is that e5 ,levin an ae front tuggers have the same size input shaft as a 21 spline w58 ?

[Casey-G]

They most certainly do, they are unbreakable little units.

Shit thing is that the cheaper more redily available dellow bell housings don't fit the flywheel.

I think there is 2 different types of gze flywheel too that's where I may be getting confused

Sent from my GT-I9300 using Motorculture mobile app

[Sprinter86]

I had read on the interwebs that niteparts bell fits even the 230mm gze clutch, but my niteparts bell had to be clearanced for even the 225mm flywheel.

not sure if my bell is different from other niteparts bells but seems to not be true, at least for my one