I have an early Microtech MTX-8 "sequential fire version 2" running a ST20V
This has internal ignition drivers (pre X4 external ignitors)

I have a set of 1NZ COPS, and want to use, preferably configured as sequential fire.

I'm not sure if I'm asking this right, but;-

What is the signal the in built ignition drivers send out from this ECU?

What is the signal I need up to the IGT pin on the COP to get it to trigger?

Is there any way of making this ECU work with 1NZ COPS?

Any help would be much appreciated.

Cheers,
Ali