wheel stuck to hub

[KKUSTOM]

hey had any had their wheel stuck to a hub before...plz share your stories and tips.

[Gunner]

rubber mallet and wd, subaru upper engine cleaner is the shit though

[ROLL3R]

I have a ke20, when i bought it was running 13 inch stock mazda rims all round. which i thought was ok, till i wanted to bolt my 13x7 hotwires on and noticed that after i took all the wheel nuts off the front wheel were pretty much welded on after years of being on the car !!! and the centre hub is smaller then the ke20. after giving it some WD40 to drink i gave it a couple of hard pulls, didnt work, so i got a rubber mallet out and bashed it well and proper, didnt work. by this point i was getting pretty cheesed off . so i jacked the front of the car as high as it would go, put full steering lock on, got a sledge hammer and gave the back of the wheel the hardest hit i could.......FINALLY !!! needless to say i dont run those 13 inch stock mazda rims anymore and i dont think anyone ever will again coz they werent very round after that

[trikzlane]

best thing is to get a rubber mallet and some boots and hit and kick the tyre side to side and up and down until it starts to free up

[H8CHIR6KU]

2 things.

1. put atleast 2 wheel nuts on 1 or 2 threads so you dont send the wheel flying off. esp with nice rims

2. dont ever get under there and try and kick it off when its on jack stands.

[Konakid]

Some one put a sto wheel on the back of my ar that was the wrong centre bore size, after some angle grinding of the rim and drum cover it eventually came off

[Javal]

This.

Deadblow rubber mallets work wonders

If it's an alloy wheel on there, it's stuck because the steel of the hub / drum corrodes to the alloy center bore on the rim.

Putting some a smatter of moly grease around the surface which the rim centers on will prevent it.

[fantapants]

1. remove wheel nuts.

2. drive till loose.

3. dont do above

[Robo86]

i used to kick my ma's off

[08ftwyo]

Spin the wheel when you hit it with the mallet.