S13 front end, Toyota studs?

[marvis]

Hi,
I have a S13 front end in my RA65 Celica. I am sick of having different wheel nuts front the front and back and then different rims.

Is there a way I can put Toyota studs into the S13 hub?

I will try this in a week as my hubs are rooted anyways

Thanks,
marvis.

[ROLL3R]

Nice products will probably do them, i'll check it out tomorrow and get back to you with a part number.

[Hen may possibly be a nut]

Yes, check niceparts catalogue. S370 rings a bell, but you'll find it soon enough.

Hen

[Jonny Rochester]

Toyota M12 x 1.5
Nissan M12 x 1.25

I reccon the different studs would bash in.

[marvis]

So the splines on them are the same? Or just bash them in?

[shakes]

use an old wheel nut with an old steel rim or big washer behind it to pull them in.

[Hen may possibly be a nut]

1 - Download niceproducts catalogue
2 - Look through it for a stud with the right knurl diameter, knurl length and total length in M12 x 1.5 (from memory S370 suits)
3 - Hit old studs out with a hammer
4 - Pull old studs in as Shakes describes
5 - ???
6 - Profit

Is it really that hard??

[marvis]

I couldn't find the nice products catalog and repco didn't have S13 in their catalog..

So a little..

I'll try it sometime next week and let everyone know

[fantapants]

hey marv... i went to a lil place near bunnings in underwood.... they had them on the shelf.

the old gilly s13 thread had all the part numbers for the different studs.... i had a hunt on the one brought over but coudnt find em.

ill have a hunt in my pile of paper and dreams for the part number i used

but in the end i just went in, acted dumb and nice, said i want a match for nissan s13 but with a 1.5 thread. He knew what i was talking about cos they carry long studs for the nissanboys...

[Hen may possibly be a nut]

Go to niceproducts.com.au
Click on "Wheel products"
Click on "Click here to Download Complete Product List"

Or here's a - right click and save