Wilwood Bias Adjuster install

[dtour]

Picked up a bias adjuster today and before i go ripping apart my shit i would like a bit of guidance. Ie, what issues i might have? mounting? what lines i have to get.

I did search for this stuff but all the threads were full of bickering and general shit.

So i really would prefer that people who have actually installed one of these give input and advice.

Pics of install and lines would be epic

Cheers,
Jon

[Andy San]

remove your standard rear bias valve, If you have a jap car they are seperate from the front ones, aussie ones are together but you can bypass it pretty easily.

work out where you want to put the new one (engine bay, interior etc) I put mine on the tunnel next to the handbrake. Putting it in the engine bay where the original one was would be a whole lot easier to fit, but a bit harder to adjust.

http://www.ae86drivingclub.com.au/dcimages/1/0/3/8/35253.jpg

that is mine installed.

not much more to it, just bleed it through and adjust it up.

[takai]

Much the same as mine, but i have mine ontop of the tunnel as the seat wings cover that area:
http://gallery2.plebeians.net/d/30836-1/IMG_1239_s.jpg

[dtour]

Cheers fellas,

so im guessing u have to bend up new hard lines?

[Andy San]

yeah, measure past where you want to mount the bias adjuster, and then cut the original one, bend up one half so it goes inside the car, and then you bend up a joining piece and connect it back to the leftover original one, saves trying to bend them up from scratch.