Digi Dash tacho with aftermarket ecu

[sdrawkcab]

I have found the threads on modifying the circuit card to get the stock tacho working with an aftermarket ecu. But what I want to know is if this mod can be done for the digital dash too? Has anyone done it? Does it require different value resistors? Cheers guys.

[LittleRedSpirit]

www.ecudatascan.com

[sdrawkcab]

Not what I'm after, cheers anyway. I want to use the stock digital cluster with my microleb lt10s and bt 20v

[FoldKing86]

Doesnt the stock tacho get its signal form the coil/s, hence it wouldnt matter what ecu your using.

[Skylar]

I think OP's talking about the ae86tachmod.pdf or whatever it was called and you're talking about the chookhouse chooning(hah, anyone even remember this?)/haltech picture with the 15v zener and 2 reg IN4001 diodes. In which case, yeah, the diode way works to get the tach working on a digi dash.

[assassin10000]

I took a brief look at a digi dash internals/circuit board, completely different and way more complicated (as to be expected). That PDF would be useless for figuring out how to modify the digi dash.

Andrew

[LittleRedSpirit]

Im sure you could play around with it and make it work, as long as you are willing to engage in some trial and error and risk breaking the unit altogether.

I took a punt a while back and adapted the ae86 tacho mod for the ae71. Works awesome.

Its probably a similar process non the less.

I dont suppose assasin would mind taking a photo of the circuit board to compare?

[Skylar]

http://www.ae86drivingclub.com.au/dcimages/2/0/2/5/554919.jpg

http://www.ae86drivingclub.com.au/dcimages/2/0/2/5/244718.jpg
Hi Hen!

[takai]

Hahha, i havnt seen that diagram from Hen for years....

[sdrawkcab]

Cheers guys. I'll dick around with it and see what I can work out