View Full Version : Torgue Settings?
gumbie
9th June 2009, 08:20 PM
Just wondering if the 16v Bigport 4AGE Tappet Cover has a torque setting on the bolts?
ke70dave
9th June 2009, 08:53 PM
Just wondering if the 16v Bigport 4AGE Tappet Cover has a torque setting on the bolts?
er...no...
if its leaking, and the gasket is in good condition, its not tight enough...
its only like a m4 bolt if that, dont swing off it.
firm but not tight...as they say
gumbie
9th June 2009, 09:52 PM
Not leaking, Just wanted to take it off and Paint it that's all lol, Thanks for the quick response :).
Jonny Rochester
9th June 2009, 11:21 PM
No torque setting as such. As a M6 nut/stud, the default setting is about 4 - 8 ft.lb depending on strength. But on a cam cover, only enough to make the seals squish a bit.
When I had an apprentice, I used to clamp a few 6mm bolts tight in the vice. I would then give them a 10mm socket and ratchet, and tell them to turn the heads till they snapped off. So then you know, on a real car they should not be as tight.
Powered by vBulletin® Version 4.2.3 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.