Reply With Quote
Slight progress in the dardy garage
engine is in!
just finished modifying the clutch fork to suit a s6 slave cyl
crossmember and rack mounted and the whole front end is back in
had to space the crossmember 12mm so the rack could clear the rear plate and sump ,no biggy....
ku31's ordered and should be on the car tomorow (apparently the last pair of ku31's In 185/55 r14 :/)
rx4 radiator and oil cooler arrived
the radiator is mounted with a 12" thermo,still working on the oil cooler
not one thing had been a simple bolt in .....
Whole engine loom is complete,really happy with it
allmost finished wiring the MSD 6al ignition box and coils
ive gone with a direct fire leading ignition setup
(one msd blaster coil for each leading plug and a Bosch gt50r for the trailing plugs)
the intake side of things is getting there too
rx4 cast manifold,50mm ida webber spacers,51 ida webber and a k&n 5.5" tall filter
the filter sits about 100 -150mm above the hood line....whoops:/
looks like I'll be running no hood for good
bride seat on bride 86 rail is fitted.will buy takata harness sometime soon
sadly the "to do" list is still a lot bigger than the "done" list .progress is progress though
