Custom Rad Support + Lights

[Mirko]

So my rad support has seen better days and thinking of scrapping it and making a custom. Some thing like this one



If anyone has any info or guides / Exp in doing it would be great. Its going to hold lights, rad, cooler, bonnet pins and will be removable to make it easy to get engine out. Just looking to speak to a few people that have done it to get good ideas

[drift kid]

As bove would be pretty easy, depends how nuts you want to go, I personally would unpick all of the radiator support and it's skirting to just leave the rails and the side's of the bay showing, clean up all of the edges, then make tabs at the top on either side for the new support bar to bolt to, then make the bar out of whatever you desire, the mounts wouldn't be too hard, the headlights half mount off of the guards anyway

[Mirko]

Yeah that was l was thinking so the support and tabs on side will be going lm thinking thanks dude. The one hypertune did for yeates 86 like in photo above is basically that and the standard l think

[drift kid]

Yeah, and that basically is just an aluminum C channel extrusion that has been waterjet cut to have that pattern in it