i will give u 65 including post to 4053 in brissy
hey guys, have for sale here a mechanical omori oil temp guage. Looking for 60ono. Very minor cosmetic scratches, nothing a can of paint couldnt fix. Numbers illuminate green whils the needle, red. Will post at buyers expense. Locared SE suburbs Melb.
Alex
数独のガレージ "Sudoku Garage" <3<3<3
i will give u 65 including post to 4053 in brissy
Quick question; where does it plug into on the engine?
3 questions
1. What size is the gauge?
2. What is the size of the fitting/thread on the end?
3. Have you ever used it?
thanks
J
Last edited by maxhag; 5th April 2009 at 01:27 AM.
1974 MX22 MARK II CORONA HARDTOP COUPE - Awaiting a full restoration
Iver never used the guage. Not sure on size of fitting, its pissing down outside and its in the garage. I know the light on it works. Think its 45mm.
The probe mayt just screw straight into the thermostat housing or if not then get a alloy pipe that is a available at super cheap or burson etc that goes halfway in the top hose of your radiator. The fitting screws straight into it.
数独のガレージ "Sudoku Garage" <3<3<3
Um its an oil temp gauge not water.
Will need to go into the oil pressure hole unless you can run an adapter with fittings for both temp and pressure.
to fit it you can just get a sandwich plate which goes in between the block and oil filter
Gl with the sale to bad its not a white series one, would have snapped it up to go with my set of omori gauges
Under your exhaust manifold towards the front of the block. Oil pressure is already there, about 2-2 1/2" diameter silver. Or as mentioned, an adaptor block between oil filter and block