4agze wiring and ECU

[keiichi]

Car - KE70

motor - 4AGZE

use - project, just bought it, not running

problem - wiring is a mess, did not come with ecu

occurs/started when - i bought it?

personal situation - my knowledge of wiring and ECU's is limited.

(will put pics up tomorrow if it helps)

ok so for some reason i bought a ke70 with a 4agze in it, not running, it has no ecu in it.

apparently it used to have an aftermarket ecu - brand name was something like ingen which had a hand controller.

the plugs are all intact and available, it used to run (drive) on the aftermarket ecu until it started to fall out of tune or something like that and got parked and left.

further information - runs off a normal distributer (as opposed to coil-packs) with (i think, at a guess) the CAS coming out of it. it appears to be basically stock except for an r33 intercooler, pod filter and extractors. pretty sure it is map sensored, not airflometered.

my question is - do i need to get an aftermarket ecu and have it re-tuned? or can i use a standard 4agze ecu?
orrrr..... wtf should i do next? what would be the best way to go about getting this running.

Thanks in advance ^_^

engine


where the coil/ignitor used to be.


only two ecu plugs


two plugs not connected. TPS on the left and on the right, is that a cold start injector?