JDM loom in ADM shell

[dtour]

So i just picked up some power windows and mirrors, stupid me i assumed the adm loom came with the associated plugs.
so i was wondering will a jdm body loom just hook straight up to all my shit in the adm shell?

My current setup is a 20v with adaptronic wired into the adm body loom.

Cheers,
Jon

[Stain]

a jdm zenki loom is pretty close to a adm loom, so is easy to swap in. there will be some slight differences that are pretty easy to work out tho.

[evil86]

i've done the swap before. make sure of a couple of things. the jdm loom your getting is analog a/c and a normal cluster. i did my conversion and got a climate control loom and have to get all a/c stuff to sure. besides that its all sweet

[Nikkojoe]

Also note that tacho wire runs different...

[dtour]

thanks fellas,

i am right to assume all the fuse boxes in the same places? and that the loom will come with all the provisions for power windows and mirrors?

nikko how different are the tacho wires?

[Nikkojoe]

Tacho wire (on a jdm zenki) runs to the firewall plug which houses the coil power (black orange), injector power (yellow), reverse lights, temp, oil pressure and starter. On an adm it runs into the passenger kick panel as a connection point to the adm engine bay loom. Also on an adm, the coil power (black orange) goes to drivers side kick panel as a connection to adm engine bay loom. If you are using these wires in your setup you just have to note where they go .

It all plugs in, same plugs (with some exception SOMETIMES to a/c plugs - dependent on year model). Not sure if the loom will come with power windows and mirrors, but this stuff isn't hard to do later... or so i've been told

[dtour]

Thanks